A Raspberry Pi GPIO remote control based on gpiozero
https://github.com/gpiozero/gpiozero
Use this all-in-one command to install remoteio as deamon on port 8509.
If remoteio is already installed, this command will update all files.
bash -c "$(wget -qLO - https://github.com/schech1/remoteio/raw/master/install.sh)"
pip install remoteio
When using pip, the server needs to be set up manually. See the examples below.
Start a remote server on port 1234.
If no port is specified default port 8509 will be used
from remoteio import run_server
if __name__ == "__main__":
run_server(port=1234)
from remoteio import RemoteServer
if __name__ == "__main__":
server_ip = "192.168.1.38"
server_port = 1234
remote_server = RemoteServer(server_ip, server_port)
remote_pin = remote_server.pin(7, 'b')
remote_pin.on(time_ms=2000) # (Optional) Time until switch off
remote_pin.blink() # Blink LED
remote_pin.pulse() # Pulse LED
remote_pin.off()
remote_server.close()
remote_pin = remote_server.pin(7, 'b') # Use physical board numbering
remote_pin = remote_server.pin(4, 'g') # Use GPIO numbering (e.g. GPIO4)