Tags: 0xB0D/u-boot
Tags
arm: renesas: r8a7795_avl: Enable correct I2C busses Reviewing the AVL IO_Config spreadsheet and the schematic shows that we have the wrong I2C busses enabled here. This change in conjunction with an updated pin-configuration for ATF should enable us to get some more activity from the I2C busses. Signed-off-by: Bryan O'Donoghue <[email protected]>
arm: renesas: r8a7795_avl: Fixup i2c declarations Fixes up the I2C bus declarations a bit. More work is required to accurately map the I2C bus devices at their correct addresses. Signed-off-by: Bryan O'Donoghue <[email protected]>
arm: renesas: avl: adas: Change LAN-Bridge GPIO settings
This patch sequences the USB LAN bridge out of reset and through wakeup.
[bod: Fixed code formatting.
Functional decomposition of code.
Fixed git log]
Signed-off-by: CostaRolls <[email protected]>
Signed-off-by: Bryan O'Donoghue <[email protected]>
arm: renesas: r8a7795_avl: Add an AVL ADAS board port Takes the Renesas ULCB and makes some minimal changes - switching on all EHCI and switching off some LEDS that look suspicious. A more in-depth dive into the schematics is required to make this work right. Signed-off-by: Bryan O'Donoghue <[email protected]>
arm: renesas: r8a7795_avl: Add an AVL ADAS board port Takes the Renesas ULCB and makes some minimal changes - switching on all EHCI and switching off some LEDS that look suspicious. A more in-depth dive into the schematics is required to make this work right. Signed-off-by: Bryan O'Donoghue <[email protected]>
arm: renesas: r8a7795_avl: Add an AVL ADAS board port Takes the Renesas ULCB and makes some minimal changes - switching on all EHCI and switching off some LEDS that look suspicious. A more in-depth dive into the schematics is required to make this work right. Signed-off-by: Bryan O'Donoghue <[email protected]>
arm: renesas: r8a7795_avl: Add an AVL ADAS board port Takes the Renesas ULCB and makes some minimal changes - switching on all EHCI and switching off some LEDS that look suspicious. A more in-depth dive into the schematics is required to make this work right. Signed-off-by: Bryan O'Donoghue <[email protected]>
PreviousNext