Platform for creating and sharing projects - OSHWLab

If I understand you correctly, you want a "keep out/prohibited" area around the hole? This can easily be done using the copper area tool. I've attached some pictures to show what you can do. Select circle on the copper area tool, size the circle to the desired radius. Copy my settings (I put it on multilayer, but you can adjust as needed). Regenerate the copper plane (shift + B). You should get the same result as I.[Picture][Picture][Picture]

First I would implement high pass filter to the audio input, if there is something like motor interference coupling to the audio signal. 1Hz signal is easy to remove with a high pass filter. High frequency hum might become from the ICL7660. You create a negative rail by switching C9 cap. I had the same effect when I used that chip. You can check it out from my published project. It was audio mixer project. Also, you might get mains frequency hum which is pain in the back side to filter out. But because main frequencies are around 50Hz-200Hz with its harmonics, then making a high pass filter on the input might help with that too. The rest of the possible interference might become from the layout. I highly suggest using start point grounding in audio circuits. I would be very interested to take a look at the layout? I may find something there.... Regards, Markus Virtanen HW / Electronics Designer

Hello, this is a new prompt for claiming coupons. Based on your feedback, we will optimize it by adding an option to prevent pop-up ads. Please wait for our optimization. We apologize for any inconvenience caused.[Picture]

Hello, the EDA editor currently only supports changing the line width, not the wire thickness.