Replies: 1 comment 2 replies
-
|
Hi and welcome! Mostly your configuration is correct. If the inside sensor you already have configured is the same as the living room temperature sensor then you should add the TRVs of the living room in the “Radiators section” instead of the “Rooms” section. If the Better thermostat climate entity of the living room controls the 2 TRVs, then add only the better thermostat climate entity in the “Thermostat” section. |
Beta Was this translation helpful? Give feedback.
-
|
Okay that's good to hear. To clarify: In Better Thermostat I have two living room TRV entities, controlled by the same temperature sensor. That temperature sensor is also the sensor I added to sat as the inside sensor. So I should remove those TRVs from the "Rooms" section. But based on my setup do I need to put them in the "Radiators" or the "Riooms" section? I just want to be sure :) |
Beta Was this translation helpful? Give feedback.
-
|
Add these two TRV entities in the Radiators section. Then you are good to go! |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
Hi everyone,
I hope you can give me some insight in what area settings I should use.
My setup is the following:
My question is: I currently have added all my Better Thermostat entities to the "Rooms" setting. Is that all I need to do or should I also add entries to "Thermostat" and "Radiators"? If yes, what entities should I put in there?
Beta Was this translation helpful? Give feedback.
All reactions