Description:
I am encountering an issue with connecting a gamepad to a remote host. The gamepad and the remote host are both on the same local network. Here’s a summary of what has been tested so far:

Network and Port Configuration:

Both the gamepad and the remote host are on the same local network.

Ports have been checked and confirmed as open.

I also tested the gamepad on a different port after recompiling the setup.

Testing with Lite3 Dog Development Board:

The gamepad was connected to a Lite3 dog development board.

After recompiling and testing on the board, I still could not capture the gamepad's UDP signal.

Expected Behavior:
The gamepad should be able to send UDP signals to the remote host or development board for further processing.

Actual Behavior:
Despite the configurations and testing steps above, the UDP signal from the gamepad cannot be captured by either the remote host or the Lite3 development board.

Any help or guidance on resolving this issue would be greatly appreciated!