Board

ESP32-CAM Ai-Thinker

Device Description

ESP32-CAM with camera attached and SD card inserted

Hardware Configuration

ESP32-CAM with camera attached and SD card inserted

Version

v1.0.6

IDE Name

Arduino IDE 1.8.19

Operating System

Xubuntu 20.04

Flash frequency

80MHz

PSRAM enabled

yes

Upload speed

115200

Description

ESP32-CAM in boot loop

Sketch

Anyone

Debug Message

rst:0x10 (RTCWDT_RTC_RESET),boot:0xb (HSPI_FLASH_BOOT)
flash read err, 1000
ets_main.c 371 
ets Jun  8 2016 00:22:57

Other Steps to Reproduce

Inserting the SD card causes the problem

Note: I didn't see the Troubleshooting Guide, it would be nice to have a link to that along with the warning when opening the issue.

But on the Internet I didn't find anything directly related to ESP32-CAM either.

Since this board model already has an SD card socket, it would be interesting to have a way to allow firmware uploads to be carried out even with the presence of the SD card. Otherwise, I have to remove the SD card and then upload the firmware via the serial port.

I have checked existing issues, online documentation and the Troubleshooting Guide

• I confirm I have checked existing issues, online documentation and Troubleshooting guide.