Simple and quick pk2cmd front end - a GUI for programming PIC microcontrollers with the PICkit™ 2 Development Programmer/Debugger and PICkit™ 3 In-Circuit Debugger/Programmer tools.

This combination supports the majority of the PIC family (10F, 12F, 16F, 18F, 24F, 32F, as well as dsPIC30 and dsPIC33) and many serial EEPROMS (24 and 25 series) - currently over 1500 devices.

The GUI supports also these programmer HW/SW combinations - but only for a limited PIC device range:

• ArdPicProg DIY programmer hard- and software.
• PICkit1 software for the PICkit™ 1 Flash Starter Kit.

Other programmer can easily be added to the file programmer.cpp.

You must have qt, qmake and make installed in your system. The program was tested with Qt5 and Qt6 on Debian stable using PICkit1, PICkit2, and ArdPicProg.

run:

qmake QPICkit.pro
make all -j4
make clean