one of my 2 D3AAs behaves incorrectly when switching between smooth and stepped ramp at floor levels. instead of staying the same if the new floor is lower, or getting brighter if the new floor is higher, it always switches to/stays at the lower floor level.

tested on 0161-2024-04-20 with SST-20 deep red, could not reproduce with 591a on the same version. only other difference between the lights is that the red one also has red button LEDs, while the 519a has an RGB button. the misbehaving light is a fresh anduril install, and i factory reset it too.

steps to reproduce:

1. go to the bottom of smooth ramp (set to level 1)
2. 3C to switch to stepped ramp (floor is 10)
   • the light should now be go to level 10, but it stays at level 1
3. ramp up (it correctly jumps to the 2nd step, 30 by default)
4. ramp back down (it goes down to 10, as expected)
5. 3C to switch back to smooth ramp
   • the light should stay at the stepped floor and allow ramping down, but it switches to smooth floor instead

not sure how it's possible that this is only happening with my SST-20 light. does it use a different driver or something?