A low-noise supply based on the LT1763.

Schematic: pdf

OSHPark: link

Gerbers: zip

The board has provisions for an RLC input filter (see schematic components R4, L1, C3).

You can populate these components with whatever values you like. I used this RLC calculator to analyze a few component values.

Note: C3 should be a film capacitor, e.g. Kemet R82 (4.7uF, 1uF).

Note: L1 should be a small-signal axial inductor (470uH, 100uH). Note that the 470uH inductor will saturate if more than 90mA is passed. This board is intended for use with e.g. an LTZ1000 circuit, which only draws about 30mA.

Note: A 10R resistor passing 30mA will add 0.3V of dropout.

The mounting holes are intended for use with M3 brass hex stand-offs.

The input and output leads fall on a 0.1" grid (breadboard compatible).