FWC-Module1

first three assignments on: Arduino

IDE: Digital Design, Combinational and Sequential Logic using the Arduino Framework

Assembly Programming: Introduction to AVR-Assembly, ATMEGA328P peripheral programming, Timers, Memory Management

AVR GCC: Introduction to AVR-GCC, Interfacing an LCD (Embedded C Programming)

next three assignments on: Matrix Analysis

line : A line perpendicular to the line segement joining the points (1,0)and(2,3)divides it in the ratio 1:n . find the equation of the line ?

circle : To find angle QPR of the triangle PQR which is inscribed in the circle $x^2 + y^2 = 25$. If Q and R have co-ordinates (3,4) and (-4,3) respectively .

conic : To find the locus of mid point of $\vec{P:Q}$ where $\vec{P}$ is (1,0) and $\vec{Q}$ is a point on the locus $y^{2} = 8x$ .

Optimization

last three assignments on: Vaman board

ARM Programming - Simple hardware interfacing using the Vaman-Cortex-M4(pygmy)

Verilog Programming - Digital Design using the Vaman-EOS-S3 FPGA

Internet of Things - Establishing a wireless sensor network using the Vaman-ESP

project

ugv - unmanned ground vehicle