This release focuses on adding support for bluetooth builds using nice!nano micro controllers.

• Added pads on the PCB to solder a battery (B+, B-).
• Added a power switch to disconnect the battery.
• Added RGB cutoff jumper pad (connected by default).
  • Slice between the pads to break the connection between Power and RGBs. RGBs use some power even when powered off, if you wish to disable them you can use this.
• Added reset switch

Warning
JLCPCB will ask for a 15€ supplement on the plate file because of the long milling time.

I decided to update the PCB design to add some features that I wanted. It remains compatible with the plate files from the previous release. (I'll republish them here for your convenience)

• Plate standoffs holes diameters reduced
• Added Kailh Hotswap socket support (switches cannot be soldered directly)
• Added underglow support with 8 adressable RGB LEDs
• LED support will be added to QMK and VIA shortly
• Update the Pro-Micro footprint with a more user-friendly design
• Added laser cut file for the bottom plate
  • To take full advantage of RGB underglow you will need a light diffuser. I recommend getting a laser cut acrylic bottom piece using the included .dxf file, instead of ordering it as a PCB with the gerber.

⚠ Warning: JLCPCB will ask for a 15€ supplement on the plate file because of the long milling time.

• Change spacebar from 3u to 2.75u
• Create top plate design
• Create bottom plate design
• Enlarge mouting holes for M2 spacers
• Change FN key from 1u to 1.25u
• Add flippable micro-controller footprint
• Remove doom eternal quote because of bad visibility on full assembly
• Lower the MCU footprint

⚠ Warning: JLCPCB will ask for a 15€ supplement on the plate file because of the long milling time.

Changelog

• Bump version
• Changed screw hole footprint
• Changed author silk location
• Corrected MCU silk
• Smaller silk screen corrections