Remove GE Hex LED control board from housing, and desolder and remove the 8051 controller (U2).

• Pin 3.3V to 3v to 5v level converter pins VA and OE
• Pin GND to 3v to 5v level converter pin GND
• Pin PIN_D to 3v to 5v level converter pin A1
• Pin PIN_S to 3v to 5v level converter pin A2

• Test point S to 3v to 5v level converter pin B1
• Test point DOUT to 3v to 5v level converter pin B2
• Test point GND to 3v to 5v level converter pin GND
• Test point V5 to 3v to 5v level converter pin VB

NOTE: The GE Hex LED will not supply enough power for the ESP-32 wifi, make sure to power the ESP-32 separately via USB!

NOTE: If running more than 6 Hex LEDs, use the GE Hex Led power cable included in the set to 'jumper' the first Hex LED to the last one.

Required Arduino libraries:

• ArtnetWifi, v1.5.1
• AutoConnect, v1.4.1
• FastLED, v3.5.0

• Flash firmware to ESP-32
• After power-on, connect to the "hex-dmx512" AP (no password), and configure the ESP-32 wifi to connect to your local Wifi network.
• Use any DMX-512 Ethernet controller to send DMX-512 packets to your lights!