Expansion card for the Ford Focus Digital Dash Motherboard

Hello world sample code for the ESP32-S3 dual CAN bus development board

Ghidra is a software reverse engineering (SRE) framework

ECUMaster Arduino 1.28inch Round Display

Dynamic LVGL code for a car RPM / speed gauge on a Waveshare 2.1" ESP32-S3 controller

Automotive_hat for Raspberry Pi

Parser for ECUMaster serial stream with EDL-1 protocol

ESP32 and ESP32-S3 board with CAN interface, runs on 12V power (with auto shutdown)

A MaxxECU compatible canbus I/O expander+screen using arduino and MCP2515

CAN Bus project for automotive racing data acquisition. Utilizes Qt Framework, C++, QML, JavaScript, and HTML5.

Arduino code to receive a canbus message and convert it to a PWM signal to then drive an analog gauge that would normally take a 0-5v sensor signal.

experimental code to emulate an haltech IO12 expander box

Control car instrument clusters from your computer for gaming or other purposes using ESP32

rusEFI 5inch display dashboard

rusEFI open source lowcost CAN-bus dashboard

CAN-ESPNOW-Display

Hardware - dingoPDM-Max is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are available or the design can be used to build a DIY version.

Hardware - USB to CAN adapter

Firmware - dingoPDM and dingoPDM-Max are open source, affordable automotive PDMs (Power Distribution Module). Pre-assembled and tested units are available or the design can be used to build a DIY v…

Firmware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.