ReadMe

How to run

1. Navigate to "build" folder and call "java -jar commOgServiceGUI.jar" or compile the code yourself and run it
   
2. Place params.txt file in dji-firmware-tools folder
   
3. Put all paramters of interest into params.txt in each line (examples are in). Not all parameters are supported by each Aircraft.
   
4. Start commOgServiceGUI.jar
   
5. Choose path to dji-firmware-tools in the GUI
   
6. Select the port of the connected Aircraft (sometimes you have to start DJI Assistant before and then close it to enable a connection like on Mavic Mini)
   
7. Select your Aircraft
   
8. Load the paramaters from file by clicking "Refresh"
   
9. Select a parameter and the values will be loaded if possible. Otherwise there will be an Errormessage
   
10. Change the value and press "Set Value" to set it. Ensure that you are within the range of maximum and minimum value
    
    
    

Information

This tool was tested on Windows 8.1 with Mavic Mini Aircraft.

Disclaimer

SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT.