OctoPrint_RepeatingCommand

Runs a command at a specified interval during prints.

I use it to trigger my home automation to run an exhaust fan (that normally turns off after 5 minutes) when printing.

Installation

Install via the bundled Plugin Manager or manually using this URL:

https://github.com/aerickson/OctoPrint_RepeatingCommand/archive/master.zip

Set a command and interval and enable it.

Licensed under the terms of the AGPLv3.

Name		Name	Last commit message	Last commit date
Latest commit History 18 Commits
extras		extras
octoprint_repeatingcommand		octoprint_repeatingcommand
test		test
.flake8		.flake8
.gitignore		.gitignore
.pre-commit-config.yaml		.pre-commit-config.yaml
.travis.yml		.travis.yml
LICENSE		LICENSE
MANIFEST.in		MANIFEST.in
README.md		README.md
babel.cfg		babel.cfg
requirements-test.txt		requirements-test.txt
requirements.txt		requirements.txt
setup.py		setup.py